What is it
It is a ESP32 Watch development board.
Why did you make it
This product was planned at the same time of deauther wristband. I learned a lot of experience from deauther wristband and I knew ESP32 is a better choice for a ‘Watch’.
The break ou pads are also designed to connect different sensors.
TX/RX could be used to communicate with computer or other control board.
17/16 is IIC port could be connected with RTC module or other IIC sensors.
SVP/SVN could input ADC signals.
25/26 could output DAC signals.
What makes it special
Small size:3.8×4.5cm
Height:1.5cm
Double 4 layer board
600mAh battery inside
On/OFF Power Switch
OLED version:1.3OLED SH1106(SDA-17,SCL-16)
Buzzer-32
WS2812b RGB LED-33
Navigation Button(Up-19,Center-18,Down-5)
OLED version external slide button(22,23)
Highlight LED(27)
Indicate charging LED(On means Charging,OFF means Full)
Reset and Flash Button at Bottom board
Break ou GPIOs(TX,RX,17,16,SVP,SVN,25,26,GND,3V)
SD Card support
GPIO12–DAT2
GPIO13–DAT3
GPIO15–CMD
GPIO14–CLK
GPIO2–DAT0
GPIO4–DAT1
GPIO21–card
Tutorial
1.Install the environment for ESP32
2.Install OLED library
3.Install Adafruit NeoPixel Library
4.Code Example for oled version
Upload config
Package Included
1 x DSTIKE ESP32 Watch DevKit
Additional information
| Weight | 0.095 kg |
|---|
Reviews