RF Wideband Low Noise Amplifier 0.1-2000MHz Gain 32dB High Frequency Amplifier with Shell

SKU: GP-1825860

$81.72

RF Wideband Low Noise Amplifier 0.1-2000MHz Gain 32dB High Frequency Amplifier with Shell
$81.72

Description
This amplifier has the advantages of wide frequency range, high gain, low noise figure, etc. It can be used in various radio frequency receiving front ends to increase the communication distance! Wide range of shortwave, FM broadcasting, remote control receivers, cable TV signal amplifiers and other places where low-noise and small-signal radio frequency amplification is required.
Specification
Working frequency:0.1-2000MHz
Working voltage:9-12V (suitable for lithium battery power supply)
Working current:37mA
Amplification gain:32dB (typical value)
F= 0.1MHz, gain=32dB
F= 500Mhz gain=32dB
F=1000MHz gain=29dB
F=1500Mhz gain=25dB
F=2000MHz gain=20dB
Maximum output:13dBm (20mW)
Noise figure:1.9dB
System impedance:50 ohms
Connector model:SMA-K (female, outer screw and inner hole)
Product size:42*36*14MM
Product weight:50 grams
How to use
RFin:Input signal amplification
RFout:output amplified signal
VCC:Positive power supply (suitable for lithium batteries)
GND:negative power supply
1) The amplifier has very good gain flatness when the frequency is less than 500MHz, and careful adjustment can be less than 1dB. The lower the frequency, the higher the gain consistency.
2) The lower limit of the operating frequency of this amplifier is restricted by the input and output capacitors. The default is 0.1uF, which can work up to 0.1MHz; the input and output capacitors can be increased appropriately to extend the lower limit of the frequency. For example, at 10uF, it can work up to 5KHz. For detailed calculations, note that the input and output impedance is 50 ohms, calculate the required capacitance value, and at the same time enhance the decoupling and voltage regulation of the power supply.
3) When the supply voltage changes between 5-8V, it can be used as a variable gain amplifier, and the gain increases with the increase of the supply voltage. It is very suitable for RF receiving front-end circuit. DA is used to control the power supply voltage to control the gain of the amplifier and play an automatic gain control.
4) When the power supply voltage is 8-10V, the low-frequency end gain reaches 30dB. At this time, the amplifier has a lower noise figure and better stability.
5) When the voltage is 12V, the gain reaches the maximum value, and the low-frequency end gain can reach 32.5dB.
Package included
1 x Amplifier

Additional information

Weight 0.023 kg

Reviews

Write review “RF Wideband Low Noise Amplifier 0.1-2000MHz Gain 32dB High Frequency Amplifier with Shell”

Your email address will not be published. Required fields are marked *


Warning: Attempt to read property "post_content" on null in /www/wwwroot/geekpaw.com/wp-content/themes/shoptimizer-child-theme/functions.php on line 714

Warning: Attempt to read property "post_content" on null in /www/wwwroot/geekpaw.com/wp-content/themes/shoptimizer-child-theme/functions.php on line 714

Shipping Methods


Payment Methods

[contact-form-7 id="230e2c7" title="Wholesale Inquiry"]