Features
– High performance 32-bit ARM processor
– Fully tested
– Supports DMR, P-25,D-Star and System Fusion
– Onboard LEDs to show status (Tx,Rx,PTT,Mode)
– Up to 10mW RF power
– SMA antenna connector,Antenna included
– Mounts cleanly on all current Raspberry Pi’s including the Pi Zero
– The firmware is pre-loaded and is easily upgraded via software.
– Open source 3D printable case available
– Uhf 430-450 MHz,433mhz and 900MHz
VHF 144 220 Opera FREQ
Install the firmware with bootloader support for USB connection.
If you want to use the device via USB port you have to install a bootloader and build the firmware with bootloader support. As the raw device cannot be used with USB you have to use a USB-serial adapter or STlink device
The upper part is TX,the lower is RX antenna.
UHF+VHF
SMA,antenna
Modem select:STM32_HS_GPIO
Set TX frequency,RX frequency
TX,RX frequency had better 10M or more apart.
SLOT1,SLOT2 support.
Note
– The firmware is pre-loaded. Please do not upgrade the firmware by yourself.
Assemble video
Package Included
1x OLED display
1x MMDVM HotSPOT Module
1x Case
2x 433Mhz antenna
2x Pins
Some screws
Additional information
| Weight | 0.131 kg |
|---|
Reviews