Features
1. 84 X 84 dot matrix LCD,can show 4 lines of characters
2. Use serial interface communicate with the master processor, the number of interface signal line reduced greatly, only 8 signal lines including power and GND. Support different types of MCU, such as the SPI, MCS51 serial mode 0 of AVR. Transfer rate up to 4Mbps, can full speed write display data without waiting time.
3. Can use the conductive glue to connect the module with the printed board,without connecting cable.The metal hooks on the module can fix the module on the printed board,which is very easy to install and replace.
4. LCD controller/driver chip has been bound to LCD chip,the volume of LCD is small
5. Low power supply,the working current in normal situation is lower than 200┢A,and has power-down mode
Specification
LCD5110 Module
Power supply voltage2.7V-3.3V,5V is OK,but part of the screen becomes black when tested
Data interface level2.7-5V
Backlight power supply voltagehighest 3.3V
Module size43.6mm x 43.1mm(width X height)
Installation diameter2mm
BacklightWhite
Note
LIGHT linked with GND, the backlight to be lit.
Need you to compress the screen and PCB tighter, might got loose after the delivery.
Use a 3.3V controller, otherwise the display could be quite vague.
RST——— reset
CE————chip selection
DC———–data/commands choice
DIN———–serial data line
CLK————serial Clock Spee
3.3V————VCC
LIGHT——— backlight control terminal
GND———–power negative
BL ———– backlight control end.
Package Included
1 x 5110 LCD Module
1 x Row needles
Additional information
| Weight | 0.025 kg |
|---|
Reviews