Specification
1.Input Voltage:DC10-14V
2.Standby Current
3.RF Frequency:433MHZ
4.RF Working mode:Super heterodyne receiver
5.Receiver Sensitivity:>90dBm
6.Remote Control Distance:>100 meter(In open environment)
7.Decoding Way:MCU Software decoding
8.Can store the number of remote control:50
9.Support remote control type:Fixed code, learning code
10.Channel:1CH
11.Multiple working modes:(Jog/Non-Latched ,inter-lock/Latched ,self-lock /Self-Latched,Delay off)
12.Wiring Method:Fixed wiring terminal
13.Working Voltage:DC12V
14.Output Current:10A
15.Rated load:10A 250VAC / 10A 125VAC
10A 30VDC / 10A 28VDC
16.Output:Normally open,Common,Normally closed
17.Dimension:3.5cm*3cm*1.6cm
Working/output way
1.Jog/Non-Latched:Press one button is Working /ON. Loosen your finger on the same button is Stop/OFF. One channel switch need one buttons remote control.
2.Self -lock/Self-Latched:Press one button for one time is working/ON. Press the same button again is stop/OFF. One channel switch need one buttons remote control.
3.Inter-lock /Latched:Press one button is working/ON, press another button is stop/OFF. One channel switch need 2 buttons remote control.
4.Delay:Press remote control relay pull-in,release the remote control and begin timekeeping,after 5s,10s,15s will automatically close the relay
Description
1.Jog:Press the learning button then release, set the mode from the system automatically working mode to action mode, wait for a while, when the board LED off, said it is into the learning state, press the remote control, the system received the signal. The LED flashes 5 times and goes off again. After 3S delay, LED light marked learning success, the system automatically withdraw from the learning state.
2.Self-locking:Press the learning button, then release, press 2 times, the system automatically set to self-locking mode, wait for a while, LED off, it is into the learning state, press the remote control, LED flash 5 times Off. 3S after the delay, LED light learning success.
3.Interlock:press the learning button, then release, press 3 times in succession, the system is set to interlock mode.
4.Delay:Press remote control relay pull-in,release the remote control and begin timekeeping,after 5s,10s,15s will automatically close the relay
Package included
5 x 12V 1CH 433MHz Wireless Relay Switch Receiver
Additional information
| Weight | 0.085 kg |
|---|
Reviews