Specification
Rated Voltage:DC 12V
Rated Power:60W
Maximum Pressure:Max. 0.8MPA
Maximum Flow:5L/min
Pump Diameter:4.8cm / 1.89inch
Pump Length:14.5cm / 5.7inch
Outlet pipe size(Dia.*L):1.1 x 140cm / 0.43 x 55inch
Inlet pipe size(Dia.*L):0.6 x 100cm/ 0.24inch x 39.37inch
Cable Length:30cm / 11.8inch
Clips Length:8cm / 3.15inch
Application
Widely used in general industrial equipment, medical equipment, chemical equipment, shipbuilding, drinks, carpet and floor cleaning, water purification and water treatment equipment, vehicle cleaning, agricultural spraying, zo pipeline pressure, air cleaning cooling, coal and metallurgical industries.
How to Use
Start to run the car engine for a while, when oil temperature turns to be about 50 degrees, start pumping oil.
Connect the pump to the power, run it for a while, and observe whether the inlet and outlet is normal.
Open the filler cap,get dipstick out, force the tube into the bottom of the joint, until the tube does not move; then put the inlet pipe from the oil dipstick into in end (the tube into the bottom of the tank, the bottom concave place, in order to pump the oil completely); as no oil or pumping up very slowly or intermittently, it is generally caused by loose pipes and fittings. You have to install the pipes and fittings again.)
After oil pumping, remove the tube, and then run the pump for a while, pump the remaining oil inside the pumping clean, or pump water for a while until the pump head gets clean.
If you have not used it for a long time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the air is all out.
Package Included
1 X Oil Pump
1 X 11mm outlet Pipe
1 X 6mm Inlet Pipe
1 X Hosepipe
Additional information
| Weight | 0.86 kg |
|---|
Reviews